[AccessD] Paper Size Problem

Elam, Debbie DElam at jenkens.com
Fri May 6 14:09:09 CDT 2005


Good thought, unfortunately it has not panned out.  I am turning off every
autocorrect I could find, including ones with no bearing on reports.  It is
still doing the same thing.

Debbie

-----Original Message-----
From: Gustav Brock [mailto:Gustav at cactus.dk] 
Sent: Friday, May 06, 2005 1:35 PM
To: accessd at databaseadvisors.com
Subject: RE: [AccessD] Paper Size Problem


Hi Debbie

Could it be the old Autocorrect bug? 
I cannot recall right now how to deal with it but look up the archive.

And check that the latest service pack is installed.

/gustav

>>> DElam at jenkens.com 05/06 7:56 pm >>>
Everywhere, several machines at the customer site just to be sure. 
Tried
changing paper size in design view and saving as the first thing on
each.

Debbie

-----Original Message-----
From: Gustav Brock [mailto:Gustav at cactus.dk] 
Sent: Friday, May 06, 2005 12:19 PM
To: accessd at databaseadvisors.com 
Subject: Re: [AccessD] Paper Size Problem


Hi Debbie

Is this happening at the customer's site?
Did you open the report at the customer in design view, change paper
size, save, open, and print?

/gustav

>>> DElam at jenkens.com 05/06 6:40 pm >>>
I have a report that has been on legal size paper for quite a while. 
Now, I am being asked to condense it (virtually illegible, but that is
what
the customer wants) onto letter size paper.  I have condensed the
report
and made the report width narrower so that it will fit on letter
paper,
however, the report still prints on legal.  

Page setup says letter, and in fact will not allow any other size to
be saved.  Changing printers has not stopped the report from printing
on
legal size paper, I have even tried importing it into a different
database to
see if that would fix it.  

This is tremendously strange, especially considering that normally I
have the opposite problem.  Access tends to make every report letter
size if
the printer changes.  I am rapidly approaching the point where I am
ready
to re-create the report from scratch, but I am hoping that one of you
knows what is going on and can direct me to a fix.

I am using Access 2002 and a SQL 2000 back end.

-- 
AccessD mailing list
AccessD at databaseadvisors.com
http://databaseadvisors.com/mailman/listinfo/accessd
Website: http://www.databaseadvisors.com
- JENKENS & GILCHRIST E-MAIL NOTICE - This transmission may be: (1) subject
to the Attorney-Client Privilege, (2) an attorney work product, or (3)
strictly confidential. If you are not the intended recipient of this
message, you may not disclose, print, copy or disseminate this information.
If you have received this in error, please reply and notify the sender
(only) and delete the message. Unauthorized interception of this e-mail is a
violation of federal criminal law. 
This communication does not reflect an intention by the sender or the
sender's client or principal to conduct a transaction or make any agreement
by electronic means.  Nothing contained in this message or in any attachment
shall satisfy the requirements for a writing, and nothing contained herein
shall constitute a contract or electronic signature under the Electronic
Signatures in Global and National Commerce Act, any version of the Uniform
Electronic Transactions Act or any other statute governing electronic
transactions.



More information about the AccessD mailing list