[AccessD] compile error

Steve Schapel steve at datamanagementsolutions.biz
Mon Jan 24 18:23:21 CST 2011


Thanks, Rocky.  As far as I know, the app works fine.  I have been given it 
to make a small modification, but there was no complaint about anythign not 
working.  But they have been using it as a MDE, so it must have compiled 
correctly at some point! :)  Needle in a haystack.

Regards
Steve

-----Original Message----- 
From: Rocky Smolin
Sent: Tuesday, January 25, 2011 11:59 AM
To: 'Access Developers discussion and problem solving'
Subject: Re: [AccessD] compile error

Check references?

Put a break point at the start of the open event of the opening form and
step through until it breaks?

How was it working before - or did it come to you broken?


Rocky


-----Original Message-----
From: accessd-bounces at databaseadvisors.com
[mailto:accessd-bounces at databaseadvisors.com] On Behalf Of Steve Schapel
Sent: Monday, January 24, 2011 2:35 PM
To: Access Developers discussion and problem solving
Subject: [AccessD] compile error

Hi.  Can anyone suggest how I might proceed here?

I am working with an Access 2003 app developed by someone else.  When I try
to compile the code, I get an error "User defined type not defined".
However, unlike other errors where you get taken to the rogue code and
highlighted, in this case there is no clue given to the specifics of the
problem.  And I have no idea where to start looking.  Any ideas?

Thanks.

Regards
Steve





More information about the AccessD mailing list