[AccessD] Revert command

Sure sounds like it then.

Bryan Carbonnell
bryan_carbonnell at cbc.ca

>>> Jdemarco at hshhp.org 20-May-03 1:24:52 PM >>>
I checked A97 in design mode after making changes.  I don't see it there.  I checked View | Toolbars | Customize to see if it was hidden away somewhere but I don't see it there either.  A search of Help turns up nothing as well.  I believe their tip was mistaken.

Thanks,

Jim DeMarco


-----Original Message-----
From: Bryan Carbonnell [mailto:Bryan_Carbonnell at cbc.ca] 
Sent: Tuesday, May 20, 2003 1:10 PM
To: accessd at databaseadvisors.com 
Subject: Re: [AccessD] Revert command


Jim,

In A2K it only show up when a  form is in design mode. It's greyed out until you actually make a change to the form, then it becomes available.

I don't have A97 here to check.