[AccessD] MIMO-G router

jwcolby jwcolby at colbyconsulting.com
Mon Nov 26 14:46:13 CST 2007


Rocky,

I am definitely looking at this, however I have had a bad experience with
power line transmission.  I have an "intercom" system which is supposed to
send the voice over the AC wiring.  It works, except that it will not send
from this circuit to that circuit etc.  I had the same issue with that same
system back in CT.  It seems the issue is the circuits in the breaker panel.
This is a physically big house, with a new addition and the original house,
plus I installed a generator and pulled some circuits into a dedicated
breaker box for the generator etc.  That Rangemax system costs just enough
that I don't want to try it. 


John W. Colby
Colby Consulting
www.ColbyConsulting.com 
-----Original Message-----
From: accessd-bounces at databaseadvisors.com
[mailto:accessd-bounces at databaseadvisors.com] On Behalf Of Rocky Smolin at
Beach Access Software
Sent: Monday, November 26, 2007 1:58 PM
To: 'Access Developers discussion and problem solving'
Subject: Re: [AccessD] MIMO-G router

John:

I struggled with the wireless thing for a couple of years.  Same problem -
weak signal even after I upgraded to the Netgear Rangemax.

I solved the problem with the Netgear wall-plugged bridge (XE102).  They're
rock solid, no installation, no configuration, no wireless security issue,
plug and play.  It's like a hard wired connection and uses you house wiring.


So no more wireless.


Rocky



 	
	

-----Original Message-----
From: accessd-bounces at databaseadvisors.com
[mailto:accessd-bounces at databaseadvisors.com] On Behalf Of jwcolby
Sent: Monday, November 26, 2007 10:24 AM
To: 'Access Developers discussion and problem solving'; 'Discussion of
Hardware and Software issues'
Subject: [AccessD] MIMO-G router

Santa dropped off one of those new routers (Netgear WPN824v2) which have a
bunch of antennas and dynamically selects the one picking up the strongest
signal and uses that for talking to the wireless computers (mostly laptops).
I have to say that it kinda sorta works.  I bought it specifically because
Mary's laptop, down a floor and a couple of rooms over, has poor reception.
I use Network Stumbler to test signal strength.  After the install, with the
old router still out there, her laptop gets roughly the same, or slightly
poorer reception via this new router in her office.  However if I take her
laptop on out to the dining room at the far end of the house, the signal
strength is definitely higher, by about 6db on average and sometimes more,
than the old router.

I am looking to buy my wife a Tivo Series 2 and will need the usb wireless
to do the phone home stuff.  It will be in the living room at the far end of
the house, so it is encouraging that I get that much better reception down
there.  I already have an old Series 1 Tivo down in the bedroom directly
below my office, and am buying a bridge to put on it to get the wireless
down to it.  Currently I am running a cable down the stairs and manually
connecting it to the Series 1 once a week to phone home.  Yuk!

I am looking to keep the old router in place however and put the new one "in
parallel", i.e. I will place a plain old vanilla 10/100 switch immediately
behind the cable modem, then plug BOTH wireless routers in to that.  Thus I
can have a wireless system (the new one) that talks to the internet, but not
to my internal (business) LAN.  The original router will talk to the
internet as well but will have its firewall between the internal LAN and the
new router.  All of the Tivos and my wife's laptop and my son's laptop will
all talk to the internet through the new router and not be behind the
business firewall (the old wireless router).

The hoops we jump through.

John W. Colby
Colby Consulting
www.ColbyConsulting.com 

--
AccessD mailing list
AccessD at databaseadvisors.com
http://databaseadvisors.com/mailman/listinfo/accessd
Website: http://www.databaseadvisors.com

No virus found in this incoming message.
Checked by AVG Free Edition. 
Version: 7.5.503 / Virus Database: 269.16.7/1151 - Release Date: 11/25/2007
4:24 PM
 

--
AccessD mailing list
AccessD at databaseadvisors.com
http://databaseadvisors.com/mailman/listinfo/accessd
Website: http://www.databaseadvisors.com




More information about the AccessD mailing list