[AccessD] Navigation pane

Thanks for the reply William. I don't see how any could be running. The
form is a report center with a lot of buttons to run various reports
with a calendar control for selecting dates. On Load the form does make
some buttons visible and others not visible. Then selecting a button may
make other buttons visible or unvisible. I set the form back to tiled
view and this one still makes the nav bar grey out. I changed the size
down to less than 8 inches and under tab mode it still takes up all the
pane. I built a new form just to see if the 9 inch form would take up
the pane and it doesn't and the nav bar will show on it. I've looked
though all the properties of both forms and can't find a difference or a
property that would cause the behavior.

Steve A. Turner
Controller
Mid-South Engineering Co. Inc
E-Mail: sturner at mseco.com and saturner at mseco.com



-----Original Message-----
From: accessd-bounces at databaseadvisors.com
[mailto:accessd-bounces at databaseadvisors.com] On Behalf Of William
Benson (VBACreations.Com)
Sent: Tuesday, June 14, 2011 7:18 PM
To: 'Access Developers discussion and problem solving'
Subject: Re: [AccessD] Navigation pane

I doubt this is possible ... but could some code be running while that
form
is opening (as in, at all times?) Maybe the navigation pane is not
enabled
while VBA is running...

-----Original Message-----
From: accessd-bounces at databaseadvisors.com
[mailto:accessd-bounces at databaseadvisors.com] On Behalf Of Steve Turner
Sent: Tuesday, June 14, 2011 5:13 PM
To: AccessD at databaseadvisors.com
Subject: [AccessD] Navigation pane

Still looking for the solution as to why in Access 2010 the Navigation
pane
grey's out upon opening a form. It only does it with one of the forms.
Using
tab mode it also goes full screen width which suppressed the nav pane.
Opening other forms this does not happen. Looked all over the web and
can't
find a solution. All these forms were built in Access 2000. Why they are
working differently I can't figure out.

 

Steve A. Turner
Controller
Mid-South Engineering Co. Inc
P.O. Box 1399
Hot Springs, AR 71902
E-Mail: sturner at mseco.com and saturner at mseco.com
Phone: (501)321-2276
Fax:     (501)321-4750
Cell:     (501)282-7751

 

--
AccessD mailing list
AccessD at databaseadvisors.com
http://databaseadvisors.com/mailman/listinfo/accessd
Website: http://www.databaseadvisors.com

-- 
AccessD mailing list
AccessD at databaseadvisors.com
http://databaseadvisors.com/mailman/listinfo/accessd
Website: http://www.databaseadvisors.com