[dba-Tech] Operating system not found

Jon Tydda jon.tydda at alcontrol.com
Fri Apr 11 10:21:22 CDT 2008


The last two I've bought don't, but a lot out there still do apparently.


Jon

-----Original Message-----
From: dba-tech-bounces at databaseadvisors.com
[mailto:dba-tech-bounces at databaseadvisors.com] On Behalf Of Rocky Smolin
at Beach Access Software
Sent: 11 April 2008 16:19
To: 'Discussion of Hardware and Software issues'
Subject: Re: [dba-Tech] Operating system not found


Batteries?  Motherboards still have batteries?

Rocky
 




 	
	

-----Original Message-----
From: dba-tech-bounces at databaseadvisors.com
[mailto:dba-tech-bounces at databaseadvisors.com] On Behalf Of Lembit
Soobik
Sent: Friday, April 11, 2008 3:33 AM
To: Discussion of Hardware and Software issues
Subject: Re: [dba-Tech] Operating system not found

thank you, Helmut, but no,
it was the battery.

Lembit

----- Original Message -----
From: "Helmut Kotsch" <hkotsch at arcor.de>
To: "Discussion of Hardware and Software issues" 
<dba-tech at databaseadvisors.com>
Sent: Thursday, April 10, 2008 9:34 PM
Subject: Re: [dba-Tech] Operating system not found


> Lembit,
> I had the same problem some time ago. Assuming that you have an AMI 
> BIOS
> the
> solution was as follows:
>
> + Enter the BIOS setup during Boot with F2
> + Go to menu "BOOT"
> + Go to the submenu "Hard Disk Drives" and hit Enter
> + Here you can see which of your drives the BIOS sees as your 1st, 2nd

> + or
> 3rd Drive.
> + BIOS will always select the 1st Drive to BOOT.
> + Make sure that the 1st Drive is the one you want to boot from. The
> selection menu shows prefixes like HDD: PM-xxxxxxx (Primary Master) or

> HDD:PS-xxxxxxx (Primary Slave)
> + My problem was, that the BIOS for whatever reasons swapped the 
> + sequence
> of
> these drives when playing with the boot device. I have not figured out

> why this happened but could reproduce the problem.
> + After getting this straightened out and having the first Boot device

> + set
> to HDD the problem was fixed.
> Summary: In addition to seeing the disks during BOOT, and having set 
> the
> 1st
> Boot Device to HDD you also have to make sure that the sequence of
your 
> hard
> disks is set to make the desired one as the first Drive.
>
> Helmut
>
>
> -----Ursprungliche Nachricht-----
> Von: dba-tech-bounces at databaseadvisors.com
> [mailto:dba-tech-bounces at databaseadvisors.com]Im Auftrag von Lembit 
> Soobik
> Gesendet: Donnerstag, 10. April 2008 19:34
> An: Discussion of Hardware and Software issues
> Betreff: [dba-Tech] Operating system not found
>
>
> I've got a PC with real puzzling behaviour:
> suddenly it tells me at boot time: Operating system not found. Now 
> this would indicate that either the HD is gone bad or
> disconnected,but:
> The BIOS shows the HD is there.
> then I started it with ACRONIS True Image.
> Acronis shows the disk and contents and lets me do an image to a 
> differnt PC, no problem here. So I took a different HD from another PC

> which has WinXP on it. Same problem - Operating system not found.
> Yes I tried a different cable - nothing.
> So I took an old HD, connected it instead of the original and started
to
> install winXP on that.
> What happened:
> It recognized the HD, let me erase it, make a partition, format it and
> copied the files and initialized configuration.
> Then it has to restart....
> instead of continuing the installation, it started over. That means,
it 
> did
> not see the HD at boot time (although BIOS does show it).
>
> now I started the WinXP install again, and when it did the restart, I 
> took the WinXP CD out. Here it should have asked for the CD, but it 
> told me Operating System NOT FOUND  again.
>
> So, it can read and write to the disk, but it won't recognise any OS.
>
> now I hooked the disk up to IDE2 - this is where it recognized the 
> Acronis disk as well as the WinXP disk, but NO, it does not find the 
> OS there either, although BIOS sees the HD.
>
> to complete the tests I have now connected the CD drive to IDE1 and 
> found,

> I
> can run Acronis fine.
>
> so the problem is, it will not recognize an OS on a HD, but it will 
> run
> from
> a CD, no matter whether on IDE1 or 2.
>
> Does anybody have an idea? or do I have to replace the MB?
>
> any suggestions welcome
>
> thanks
> Lembit
>
> _______________________________________________
> dba-Tech mailing list
> dba-Tech at databaseadvisors.com 
> http://databaseadvisors.com/mailman/listinfo/dba-tech
> Website: http://www.databaseadvisors.com
>
> _______________________________________________
> dba-Tech mailing list
> dba-Tech at databaseadvisors.com 
> http://databaseadvisors.com/mailman/listinfo/dba-tech
> Website: http://www.databaseadvisors.com
>
>
> --
> No virus found in this incoming message.
> Checked by AVG.
> Version: 7.5.519 / Virus Database: 269.22.11/1368 - Release Date: 
> 09.04.2008 16:20
> 

_______________________________________________
dba-Tech mailing list
dba-Tech at databaseadvisors.com
http://databaseadvisors.com/mailman/listinfo/dba-tech
Website: http://www.databaseadvisors.com

No virus found in this incoming message.
Checked by AVG. 
Version: 7.5.519 / Virus Database: 269.22.12/1372 - Release Date:
4/10/2008
5:36 PM
 

_______________________________________________
dba-Tech mailing list
dba-Tech at databaseadvisors.com
http://databaseadvisors.com/mailman/listinfo/dba-tech
Website: http://www.databaseadvisors.com






More information about the dba-Tech mailing list