Drew Wutka
DWUTKA at Marlow.com
Tue Jul 28 09:24:56 CDT 2009
LOL. Sounds like you had fun! Drew -----Original Message----- From: accessd-bounces at databaseadvisors.com [mailto:accessd-bounces at databaseadvisors.com] On Behalf Of jwcolby Sent: Tuesday, July 28, 2009 7:06 AM To: Access Developers discussion and problem solving Subject: [AccessD] Finally! Second access point in my house Well, I finally accomplished it, creating a second WIRED wireless access point at the far end of a cable at my house. I am doing the "responsible parent" thing and creating the public location computer for my kids, out in the living room. Unfortunately the available location was across the room from the cable that I had run for my Windows Media Center PC, so I needed wireless. While I had a wireless access point mid house in the basement directly under my wife's office, by the time the signal got up to the PC in the living room it was just too weak to hold a reliable connection. I have been trying for AGES to get a second access point in the house. It seems so simple, place a second wireless AP (a wireless router) at the far end of the cable and let it broadcast on a different channel. Well.... I had tried and tried and TRIED different things but last night, quite by accident(kinda) I found the solution. The solution in MY CASE was to turn off the SPI firewall, turn off the DHCP server, set the channel to the far end away from the other AP (primary AP on channel 11 and secondary on channel 1), and feed the data into the AP via the router ports - NOT the WAN port. To be honest, feeding the WAN port MIGHT work, however once I got it running (which happened feeding it via the router port) I didn't go back and try it. A wireless router has two independent interfaces, each of which requires an IP address to access. However it is the router interface which is used to program the router, and this IP address normally sits at 192.168.0.1. In my case I had changed my address range to 192.168.122.1 to 192.168.122.255. Thus my main router sits at 192.1687.122.1. My second access point had to be modified to be something in the 192.168.122.x range so I put it up at the top end, 192.168.122.149. Thus to program that router (the second AP) I had to now use that address. Though it is hard to tell precisely, I think the key was to turn off the firewall. The radio used to transmit the signal appears to hang off of the WAN side of the box, which is why I was originally trying to feed the signal into the wan port, but with the wan side not connected to the internet, the SPI firewall is no longer needed. So that is it. I have successfully turned a full on router into a simple wireless access point hanging on the far end of a cable. I have more signal than you can shake a stick at in my living room, and that part of life is good at Colby Manor. -- John W. Colby www.ColbyConsulting.com -- AccessD mailing list AccessD at databaseadvisors.com http://databaseadvisors.com/mailman/listinfo/accessd Website: http://www.databaseadvisors.com The information contained in this transmission is intended only for the person or entity to which it is addressed and may contain II-VI Proprietary and/or II-VI Business Sensitive material. If you are not the intended recipient, please contact the sender immediately and destroy the material in its entirety, whether electronic or hard copy. You are notified that any review, retransmission, copying, disclosure, dissemination, or other use of, or taking of any action in reliance upon this information by persons or entities other than the intended recipient is prohibited.