[AccessD] Access 2016 w/MDB's

[John Bodin]

Yes, mdb is data only and using Jet 4.0.  Good to know about A2013 dropping 3.0 support.  Thank you.

John

-----Original Message-----
From: AccessD [mailto:accessd-bounces at databaseadvisors.com] On Behalf Of Jim Dettman
Sent: Friday, March 02, 2018 4:31 PM
To: 'Access Developers discussion and problem solving'
Subject: Re: [AccessD] Access 2016 w/MDB's


 Should not be an issue.

 I don't have direct experience with that setup, but as long as it's in JET
4.0 format and data only, that is still supported in A2016 and there is no reason to think it would be a problem.

 Starting with A2013, JET 3.x support was dropped.

Jim.

-----Original Message-----
From: AccessD [mailto:accessd-bounces at databaseadvisors.com] On Behalf Of John Bodin
Sent: Wednesday, February 28, 2018 1:03 PM
To: Access Developers discussion and problem solving
Subject: [AccessD] Access 2016 w/MDB's

Do any of you have experience in running a back-end Access MDB with a front-end Access 2016 along with other A2k3 and below front-ends?  Data
portion of the Database is MDB format.   I know it can be done, just have a
potential multi-version access front-end project that will be banged on 10 hours a day every day and didn't know how reliable the 2016 version is running the older MDB format.  Thanks.

John

--
AccessD mailing list
AccessD at databaseadvisors.com
http://databaseadvisors.com/mailman/listinfo/accessd
Website: http://www.databaseadvisors.com

--
AccessD mailing list
AccessD at databaseadvisors.com
http://databaseadvisors.com/mailman/listinfo/accessd
Website: http://www.databaseadvisors.com